Integrating Autoware with a differential drive vehicle#

1. Introduction#

Currently, Autoware assumes that vehicles use an Ackermann kinematic model with Ackermann steering. Thus, Autoware adopts the Ackermann command format for the Control module's output (see the AckermannDrive ROS message definition for an overview of Ackermann commands, and the AckermannControlCommands struct used in Autoware for more details).

However, it is possible to integrate Autoware with a vehicle that follows a differential drive kinematic model, as commonly used by small mobile robots.

2. Procedure#

One simple way of using Autoware with a differential drive vehicle is to create a vehicle_interface package that translates Ackermann commands to differential drive commands. Here are two points that you need to consider:

Create vehicle_interface package for differential drive vehicle
Set an appropriate wheel_base

2.1 Create a `vehicle_interface` package for differential drive vehicle#

An Ackermann command in Autoware consists of two main control inputs:

steering angle ( $\omega$ )
velocity ( $v$ )

Conversely, a typical differential drive command consists of the following inputs:

left wheel velocity ( $v_l$ )
right wheel velocity ( $v_r$ )

So, one way in which an Ackermann command can be converted to a differential drive command is by using the following equations:

$v_l = v - \frac{l\omega}{2}, v_r = v + \frac{l\omega}{2}$

where $l$ denotes wheel tread.

For information about other factors that need to be considered when creating a vehicle_interface package, refer to the vehicle_interface component page.

2.2 Set an appropriate `wheel_base`#

A differential drive robot does not necessarily have front and rear wheels, which means that the wheelbase (the horizontal distance between the axles of the front and rear wheels) cannot be defined. However, Autoware expects wheel_base to be set in vehicle_info.param.yaml with some value. Thus, you need to set a pseudo value for wheel_base.

The appropriate pseudo value for wheel_base depends on the size of your vehicle. Setting it to be the same value as wheel_tread is one possible choice.

Warning

If the wheel_base value is set too small then the vehicle may behave unexpectedly. For example, the vehicle may drive beyond the bounds of a calculated path.
Conversely, if wheel_base is set too large, the vehicle's range of motion will be restricted. The reason being that Autoware's Planning module will calculate an overly conservative trajectory based on the assumed vehicle length.

3. Known issues#

Motion model incompatibility#

Since Autoware assumes that vehicles use a steering system, it is not possible to take advantage of the flexibility of a differential drive system's motion model.

For example, when planning a parking maneuver with the freespace_planner module, Autoware may drive the differential drive vehicle forward and backward, even if the vehicle can be parked with a simpler trajectory that uses pure rotational movement.